HVAC Repair in Vinton, VA
Homes here need heat from October through April and cooling from June through September. If your system quits, tell us what it's doing and a licensed contractor who covers Roanoke County will get in touch.
Tell us about the job
It takes about a minute.
Vinton runs its system almost all year
Homes in Vinton need heat or cooling eleven months out of the year. Heat runs October through April, with winter nights averaging 28°F. Cooling runs June through September, with afternoons near 84°F. That leaves a furnace or heat pump and an air conditioner little time off, and each start and stop wears on the parts that make it run.
Nearly half of Vinton homes heat with electricity, so a heat pump or electric furnace working through those 28°F nights matters. Roanoke County has seen 19 winter storms and 136 damaging wind events over the past ten years, and across Virginia, 22% of households went at least 24 hours without power in 2024. Most systems come back on their own once power returns. If yours does not, that is worth a call.
- 7 months
- October through April, your system heats
- 4 months
- June through September, it cools
- 28°F
- the average winter night it heats against
- 84°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Virginia requires HVAC contractors to hold a state license.
The Board for Contractors tests and licenses the contractor, not the job in front of you. That record follows the business from one house to the next. That is what a license is for. In Virginia, work under $1,000 falls outside that requirement, so a small repair can legally be done without one.
A repair on a heating and cooling system is well past that threshold, so it is the kind of job this rule was written for. The license is what stands behind whoever does the work, a contractor the state has tested and keeps a record of, not just a name on a truck.
Sources: Virginia General Assembly · Virginia Department of Professional and Occupational Regulation
- Why is my heat not working?
- Start with the thermostat. Make sure it is set to heat, not cool, and that the temperature is actually set above the room temperature. If that looks right, check your breaker panel, since a tripped breaker will shut the whole system down with no warning. Gas furnaces will also stop if the pilot light or igniter fails, and electric furnaces can trip a breaker if a heating element fails. If the thermostat has power and the breaker is fine but no heat comes on, the problem is inside the furnace and a contractor needs to look at it. With winter nights here averaging 28°F, this is not something to leave for long.
- Why is my system running but not cooling the house?
- The blower can run without the compressor doing its job, which is why you feel air movement but no cold air. Check your air filter first. A filter clogged with dust blocks airflow across the indoor coil and can freeze it, and once that coil ices over the system blows air but stops cooling. Also check the outdoor unit. If the fan outside is not spinning, or if you notice ice on the refrigerant lines, that points to a refrigerant or compressor problem a contractor needs to diagnose. On an 84°F afternoon this shows up fast, since the system has to work harder to keep up.
- What can I check before calling for HVAC repair?
- Check the thermostat settings first, including the mode, the temperature, and the batteries if it has any. Then check your breaker panel for anything tripped, since a reset breaker solves more no-heat and no-cool calls than people expect. Look at the air filter next and replace it if it is gray or clogged, since restricted airflow causes problems on both the heating and cooling side. If your system uses a furnace with a pilot light, confirm the pilot is lit. Once you have checked these, a contractor can focus on the actual problem instead of the basics.