HVAC Installation in Newport News, VA
A new system here will heat from November through April and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Newport News will get in touch.
Tell us about the job
It takes about a minute.
Newport News asks for both heat and air, most months
Eleven months out of the year, a system here is doing one job or the other. Heat from November through April, when winter nights average 33°F. Cooling from May through September, with summer afternoons averaging 87°F. Whatever gets installed has to handle both sides without much of a break between them.
Most homes here heat with electricity, so a new system needs to be able to lean on that hard for six months straight. Storms are a real part of the picture too. Virginia saw 22% of households lose power for a full day or more in 2024, and this area has logged 31 damaging wind events and 6 winter storms over the past ten years. A furnace with a standing pilot will relight on its own once the gas is flowing again. Most other systems need the power itself to come back before they run.
- 6 months
- November through April, your system heats
- 5 months
- May through September, it cools
- 33°F
- the average winter night it heats against
- 87°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Virginia requires HVAC contractors to hold a state license.
The Board for Contractors licenses the contractor, not the job, so the license covers the business doing the work rather than this specific install. Virginia only sets that aside for jobs under $1,000, which a heating and cooling system install will be well above.
In most cities and counties, an install like this also needs a permit from the local building office, with an inspection once the work is done. That is separate from the license, and it is where the installation itself gets checked.
Sources: Virginia General Assembly · Virginia Department of Professional and Occupational Regulation
- When should I replace my HVAC system?
- Once your system needs repair more winters and summers than not, or the repairs keep adding up, it is time to start pricing a replacement. An older furnace or air conditioner working hard is more likely to fail when you need it most, and here that means a cold night between December and February or a 87°F afternoon in summer. If your energy bills have crept up with no other explanation, the system is likely losing efficiency even if it has not broken down yet. A contractor can look at the actual unit and tell you whether repair still makes sense or whether replacement is the better move.
- Should I replace my furnace and air conditioner at the same time?
- If both are close in age, yes, it usually makes sense to replace them together. A furnace and air conditioner installed at the same time are matched to work as one system, and pairing an old unit with a new one can mean the new one never runs at its best. Homes here need heat from November through April and cooling from May through September, so both sides of the system get real use most of the year. If one is much newer than the other, a contractor can tell you whether it is worth keeping for now or replacing early to match the new unit.
- What happens during an HVAC installation?
- A contractor removes the old furnace, air conditioner or heat pump and sets the new equipment in place, connecting it to the ducts, refrigerant lines, gas or electric supply, and thermostat wiring. They will check the ductwork for leaks or sizing problems, since a new system connected to bad ducts will not perform the way it should. Once everything is running, they test it, check refrigerant charge and airflow, and walk you through the thermostat. This job needs a licensed contractor, and most cities and counties require a permit and an inspection once the work is done. A contractor will price the job once they see the house.